Table of Contents
Advertisement
User Manual
7. Using 4×12 mm screws (provided) to fix the 2 spacers as
per Figure 4.
8. With assistance, mount dryer on wall bracket. See Figure 5.
FIGURE 4
FIGURE 5
09
spacers
12mm long screws
Inverted (Upside down) Installation
For convenient using, this dryer can be up-side-down
installation. The installation step as below:
1. Take off the rubber plugs on the top of the unit as per
Figure 6). Then take off the four legs from the bottom as
per Figure 7.
FIGURE 6
FIGURE 8
2. Place the dryer upside-down and install the four legs
at the bottom (top side of the original dryer, as Figure 8).
Push rubber plugs inside holes on the top of the dryer
(Bottom of the original dryer, as Figure 9).
3. There is an alternative inverted control panel in the
accessories bag. Peel off the protective paper and stick it
over the existing panel, as per Figure 10.
Inverted Wall Mounting Installation
You can install the dryer inverted (upside down)
and wall mounted by following the instructions under
'Wall Mounting Instructions' and 'Inverted (Upside down)
Installation)' headings.
FIGURE 7
FIGURE 9
Advertisement
Table of Contents
