Table of Contents
Advertisement
User Manual
Cleaning & Maintenance
Cleaning the Lint Filter
Please unplug the power cord prior to any cleaning.
The lint filter must be in place whenever drying. It must be
cleaned before each use.
Removing the filters
Remove by pulling outwards with fingers, inserted into the
four holes around the exhaust vent shroud. The filter is in 3
parts: Exhaust vent shroud, lint filter and exhaust filter (as
shown in Figure 10).
FIGURE 10
Cleaning the filter
Separate Exhaust Vent Shroud, Lint Filter and Exhaust filter.
Clean the lint off the lint filter and exhaust filter with a soft
brush or vacuum cleaner. Do not damage the filters (as
shown in Figure 11).
FIGURE 11
Reinstalling the filter
After cleaning, assemble in the sequence of Exhaust filter
— Lint filter — Exhaust vent shroud, align the recesses
in the center with the projection in the center of the drum.
Make sure that it is firmly inserted (as shown in Figure 12).
NOTE: The filter fixed on the bottom of the drum should also
be cleaned with a soft brush.
FIGURE 12
13
Cleaning of the Air Intake Filter
• The filter should be cleaned once a month.
• Remove by pulling outwards holding the upper and lower
ends of the air intake shroud. Remove the filter inside the
shroud and clean it with a soft brush. Reassemble and
install as before.
FIGURE 13
Slightly push upwards with your thumb until the latch hook
disconnects, then remove.
Cleaning the interior & exterior of the Dryer
• Do not wash directly with water.
• Do not use thinner, gasolene or alcohol. Do not use any
type of spray cleaner when cleaning the interior. If dryer
drum becomes stained, clean the drum with a damp cloth.
• Remove any residue before drying the next load. Clean
cabinet with mild soap and water. Do not use harsh or
abrasive cleaners, this could damage the dryer.
WARNING: Regularly clean the lint trap.
CAUTION! HOT SURFACE
Do not touch the intake during the during cycle due
to high temperatures.
Advertisement
Table of Contents
