Table of Contents
Advertisement
User Manual
Installation Instructions (Continued)
Wall Mounting Instructions
1. Determine dryer position on wall and mark required
bracket position. This dryer is not suitable to be directly
placed on top of a washing machine.
• A minimum 50mm is needed between the top of the
dryer and the ceiling for ease of installation.
• If mounting above a washing machine, allow sufficient
room to open the lid of the washer.
Requirements for plaster or wooden wall mounting
1 × Drill & 3mm Bit
1 × Phillips Head
4 × Wood Screw, 012 × 50mm Timer Screws
1 × Helper to assist lifting the dryer onto the wall
Wall Mounting Kit
2 × Hanging Brackets
2 × Plastic Spacers
1 × Exhaust Connector
4 × 25mm Long Screws
4 × 12mm Long Screws
2. Fix the wall hanging brackets (2 supplied) to the wall
securely (e.g. into the stud). Fit a timber slat between the
studs to mount the brackets if the stud position is too wide.
FIGURE 1
563mm
08
Ceiling
3. To install the hanging hook to timber, start at Figure 2.
4. Align hanging hooks and fasten screws tightly.
5. Install the Exhaust Connector. Adjust the direction to suit
the installation (as per Figure 3).
6. Rotate the Connector clockwise to fix the pipe to the
Connector Base. Tighten.
FIGURE 2
Hanging Hook
Timber (not included)
FIGURE 3
Connector Base
Exhaust Connect & Flexible Pipe
OCD45W.1
Advertisement
Table of Contents
