Advertisement
4.
INSTRUCTIONS
4.1.
Prior to use of the required
attachment, disassemble and
grease as shown in fig.1.
Reassemble the attachment.
4.2.
Screw the attachment into the
shaft, as shown in fig.2. Tighten
the attachment using a wrench.
Note: Do not over tighten.
4.3.
Ensure the attachment jaws
are completely closed and insert
the attachment into the inner
diameter of the bearing, fig.3.
4.4
Turn the handle clockwise to
open the attachment jaws to
grip the bearing. See fig.4.
4.5.
Hold the bearing puller as shown
in fig.5, slide the hammer to the
bearing end of the shaft and
then forcefully pull the hammer
to the other end of the shaft.
4.6.
Ensure the bearing is being
pulled out evenly, if not, remove
the puller attachment and, using
a soft faced mallet, tap the
bearing until it is seated evenly.
4.7.
Repeat paragraphs 4.5 and 4.6
until the bearing has been
removed.
4.8.
Turn the handle anticlockwise to
close the jaws in order to
release the bearing from the
attachment head. See fig.5.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Fig.1
Tighten
Fig.2
Bearing
Attachment Head
Fig.3
Attachment Head
Fig.4
Attachment Head
Fig.5
Hammer
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
Grease
Attachment Head
Open jaws
Hammer
01284 757500
01284 703534
email
AK714.V2
Loosen
Close Jaws
www.sealey.co.uk
Web
sales@sealey.co.uk
Issue No.1 06/11/09
Advertisement
