Time Code/User Bits - JVC BR-S622E Instructions Manual

TIME CODE/USER BITS
This system simplifies location and specification of video frames
by marking each frame with an 8-digit code number or "address".
Essential for accurate editing, these "addresses" represent
absolute tape positions and are displayed in hours, minutes,
seconds, and frames, allowing you to specify exactly where
edits are to start and stop by entering the IN and OUT time code
values.
There are two different time code systems: LTC and VITC.
LTC (Longitudinal Time Code)
VITC (Vertical interval Time Code)
"User bits" is a portion of the time code signal allocated to the
user. It can be used to record the operator number or reel
numbers.
editing suites controlled via 9-pin serial interface.
® Install the SA-R22E TC board in the BR-S622E.
NOTES:
When editing with VITC using SA-T22E's TBC, set menu item
#601 V BLANK MASK to "00 — OFF". (c= p.32)