Related Manuals for HBM Machines HBM 250
Summary of Contents for HBM Machines HBM 250
- Page 1 HBM 250 x 550 Vario Metaaldraaibank Compleet met Dwarsvoeding HBM Machines B.V. Grote Esch 1010 2841 MJ Moordrecht Tel: 0031 182 525468 Fax: 0031 182 635119 E-mail: info@hbm-machines.com Website: www.hbm-machines.com...
-
Page 3: Warranty
Please note that the examples of external causes are not comprehensive. In no case shall HBM Machines be liable for the death or injuries of persons, for damages to goods or to the machinery itself, which was caused by... - Page 4 The cost of returning the machinery or its part to you shall be borne by HBM Machines. In case of our customer service ascertaining that there is no fault in...
-
Page 5: Safety Measures
SAFETY MEASURES 1. Only well trained personnel is allowed to operate this machine. In case you are unfamiliar with this type of machine, please get educated before you start operating it! 2. All safety shields must remain intact and in place. Removal of safety shields is strictly prohibited. - Page 6 (if possible) do not accept your delivery. In case your product arrives in damaged condition (whatever the cause) but the packing case is intact, contact HBM Machines. In case of doubt, ring HBM Machines. In case of obvious damage, always take photographs a proof of your statement about damage may be required.
- Page 7 where the product is used, which makes consulting them easier. 7. After a product has been installed in its intended site, please check if measures taken/ adjustments made, intended for transport, lifting and hoisting only, must be undone or rectified before using the product. HOISTING AND LIFTING 1.
- Page 8 2. When lifting a load, follow the manufacturer s guidelines concerning the points where hooks, straps, bars, chains etc. are to be attached, and also concerning the protection of the product from damage (e.g. to the paint) resulting from the use of hoisting and lifting devices. If you don t comply, you will be responsible for all consequences.
- Page 10 TABLE OF CONTENTS...
- Page 27 MAINTENANCE NOTES: NOTES: NOTES:...
-
Page 28: Troubleshooting
TROUBLESHOOTING Problem Possible Reason Elimination... - Page 29 -F Vario...
- Page 34 Snap Ring Gear Snap Ring Shaft Snap Ring Gear 4x30 4x60 Shaft Gear Drain Plug Gearbox Screw Screw M6x10 Screw M6x10 Flange Bearing Gear Shaft Separator Gear Snap Ring 4x14 Shaft 4x10 Snap Ring Gear Bearing Flange Screw M6x12 Cover Screw Ball Knob...
- Page 36 Handle Screw Tool Slide Screw Handle Base Washer Tool Rest Bolt Swivel Base Leadscrew Screw Zero Indicator Handle Clamping Ring Screw Graduated Collar Screw Screw Screw Bush Bracket Graduated Collar Handlewheel Screw M4x12 Screw M8x25 Cross Slide Screw Wiper Lock Screw Screw...
- Page 39 Parts No. Description Specification Qty. collar gear collar screw shaft gear worm shaft washer worm gear circlip for shaft worm scrwe worm knob shaft collar nut knob screw screw screw apron screw control knob screw screw label oil sight control cam cam shaft wheel shaft...
- Page 40 Parts No. Description Specification Qty. handle shaft handle collar handle shaft shaft gear gear shaft feed knob screw label screw steel ball spring screw handle collar handle shaft shaft screw handle knob handle shaft...
Need help?
Do you have a question about the HBM 250 and is the answer not in the manual?
Questions and answers