Drying Steps; End Time - Beko B5DT510446W User Manual

First setup of the HomeWhiz applic-
ation must be complete for the
bluetooth connection to be activ-
ated. After setup, pressing the re-
mote control function button while
the knob is at Download Pro-
gramme/Remote Control position
will automatically activate the
bluetooth connection.

6.12 Drying Steps

Iron Dry
Drying is performed until the Iron Dry step
is reached at the drying level.
Cupboard Dry
Drying is performed until the Cupboard Dry
step is reached at the drying level.
Extra Dry
Drying is performed until the Cupboard Ex-
tra Dry step is reached at the drying level.
The dryness level may vary depend-
ing on the laundry mixing and ma-
terial type as well as amount and
wetness level.
Clothes containing lace, tulle, stone,
beads, sequins, wires etc. and laun-
dry with high silk content should
not be dried in the machine.
Timed Drying – minute
To achieve the desired dryness level at a
low temperature, you can choose from dry-
ing durations of 30, 90 and 150 minutes.
When drying a small amount of laundry
(maximum 2 items), the timed drying steps
in Cotton or Synthetic dry programmes
should be selected.
If the laundry is not at the desired dryness
level at the end of the drying programme,
timed drying can be selected to finish the
process.
When this function is selected, the machine
performs drying for the set time regardless
of the drying level.

6.13 End Time

Time display
When the end time function is selected, the
remaining time until the programme starts
is shown in hours such as 1h, 2h, and the
remaining time to complete the programme
after your programme starts is shown in
hours and minutes as in the 01:30 example.
Programme duration may differ
from the values in section "Pro-
gramme and consumption table"
depending on the water pressure,
water hardness and temperature,
ambient temperature, amount and
the type of laundry, auxiliary func-
tions selected and the changes at
the mains voltage.
After a certain period of time after
the end time function is activated,
the machine goes into standby
mode and some LEDs on the
screen turn off. If there is any user
input, the LEDs will turn on again.
With the End Time function, the end time of
the programme may be set up to 24 hours.
After pressing End Time button, the pro-
gramme's estimated ending time is dis-
played. If the End Time is set, End Time in-
dicator is illuminated.
EN / 39