Handlebar Switches - Yamaha FZ-07 2016 Owner's Manual

Instrument and control functions
Brightness control mode
1
4
1. Brightness level display
The brightness control mode allows
you to adjust the brightness level of the
multi-function meter unit.
To adjust the brightness
1. Turn the key to "OFF".
2. Push and hold the left set button.
3. Turn the key to "ON" and continue
pushing the left set button until the
display switches to the brightness
control mode.
4. Push the right set button to set the
brightness level.
5. Push the left set button to confirm
the selected brightness level and
exit the brightness control mode.

Handlebar switches

Left
1
2
3
4
1. Pass switch " "
2. Dimmer switch " / "
3. Turn signal switch " / "
4. Horn switch " "
Right
1. Start/Engine stop switch "
2. Hazard switch " "
4-10
EAU1234M
Pass switch "
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to " ", the passing switch has no ef-
fect.
Dimmer switch "
Set this switch to "
beam and to "
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
1
Horn switch "
Press this switch to sound the horn.
2
/ / "
EAU12352
"
EAU12401
/ "
" for the high
" for the low beam.
EAU12461
/ "
". To signal a left-hand
". When
EAU12501
"