Troubleshooting - Power Acoustik PACD-888R Instruction Manual

Hide thumbs Also See for PACD-888R:
Table of Contents

Advertisement

TROUBLE SHOOTING
Before going through the check list, wiring connection, should any of the
problem persist after check list has been made, consult your nearest service
dealer.
Symptom
No power
Disc cannot
be loaded or
ejected
No sound
The operation
keys do not
work
Sound skips
The radio does
not work
the radio
station
automatic
selection does
not work
Cause
The car ignition is not on.
Presence
of CD disc inside
the player
inserting the disc in upside
down
Compact disc is extremely
dirty or defective
Temperature inside the
car is too high
Condensation
Wiring is not properly
connected
The built-in microcomputer
is not operating properly
due to noise
The installation angle
is more than 30 degrees
The disc ts extremely
dirty or defective
The antenna
cable is not
connected
the signals are too weak
If the power supply is properly
connected to the car accessory
switch the ignition key to " ACC "
The fuse is blown
Replace the fuse
Remove the disc in the player
then put a new upward
Insert the compact disc with
the label facing upward
Clean the disc or try to play a
new one
Cool off until the ambient
temperature returns to normal
Leave the player off for an
hour or so, then try again
Volume is in minimum
Adjust volume to a desired level
Check wiring connection
Press the RESET button
front panel is not properly
fix into its place
Adjust the installation angle
to less than 30 degrees
Clean the compact disc/try to
play a new one
Insert the antenna cable firmly
select a station manually

Advertisement

Table of Contents
loading

Table of Contents