Page 1
Overview ............................... 2 Prerequisites ..............................2 Hardware Retrieval ............................2 Installing the Terminal to the Extension Pole ....................2 Attach the Terminal Cable to the Counter ....................5 Page 1 of 6 A35 Extension Pole - Assembly Instructions.docx Updated: 2023-12-20...
Page 2
This document explains how to mount the PAX A3S terminal to its extension pole. Prerequisites Befgore you begin mounting your PAX A35 terminal on its extension pole, make sure you have all the necessary materials: PAX A35 terminal already connected to the multi-function cable •...
Page 3
4. While holding the component in position, turn the pole over and align the plate affixed to the terminal with the opening on the front of the pole to match the parts together as shown below: Page 3 of 6 A35 Extension Pole - Assembly Instructions.docx Updated: 2023-12-20...
Page 4
NOTE: Be sure to match the orientation of the mounting brackets shown in the image above. 8. After the mounting brackets are correctly installed, gently pull on the cable. If the brackets are securely screwed on, the cable should not move. Page 4 of 6 A35 Extension Pole - Assembly Instructions.docx Updated: 2023-12-20...
Page 5
1. Use a pen or pencil to mark the spot under the countertop where you want to install the fasteners. 2. Using an 11/64" bit, drill a pilot hole about 1/4" deep on the marks. Page 5 of 6 A35 Extension Pole - Assembly Instructions.docx Updated: 2023-12-20...
Page 6
4. Slide the nylon ties through the fastener channels. 5. Secure the PAX A35 cable under the countertop by tightening the nylon ties. After securing the cable, you can cut off the excess nylon ties. The result should resemble like the following...