Table of Contents
Advertisement
20
Adjusting the Thermostat
Oven temperature controls will
gradually shift after years of use. So,
even though your new oven is
properly adjusted to provide
accurate temperatures, it may cook
faster or slower than your old oven.
If, after using the oven for a
period of time, you are not satisfied
with the temperature settings, you
can adjust them by following these
steps:
1. Tum the Thermostat to the off
position. Pull knob straight off
and flip it over.
2. Loosen the screw 44 turn with a
Phillips screwdriver. Note the
position of the notches.
Locking screw
To lower
To raise
3. To lower the temperature, hold
knob handle firmly and move the
bar a notch closer to LO. Each
notch equals about 10°F (5°C).
4. To raise the temperature, hold
knob handle firmly and move the
bar a notch closer to HI. Each
notch equals about 10°F (5°C).
5. Tighten the screw and replace
the knob.
Oven Light-
Operation/Replacement
The oven light comes on when the
oven door is opened. To tum the
light on when the oven door is
closed, push the Oven Light Switch
on the control panel. Push the
switch again to turn off the light.
AWARNING
Electrical Shock and Personal
Injury Hazard
e Make sure oven and light
bulb are cool and power to
the oven has been turned
OFF before replacing the
light bulb. Failure to do so
could result in electrical
shock or burns.
e The lens must be in place
when using the oven. The
lens protects the bulb from
breaking, and from high
oven temperatures. Because
lens is made of glass, be
careful not to drop it.
Broken glass could cause
To replace the oven light bulb:
1. Tum off power at the main
power supply.
. Unscrew lens from housing.
. Unscrew light bulb and replace
with a 40-watt appliance bulb.
. Replace the lens.
. Tum power back on at the main
power supply.
IMPORTANT: Make sure oven light
is Off during the Self-Clean cycle.
Keeping oven light on will shorten
bulb life.
Ww WN
Advertisement
Table of Contents
