Table of Contents
Advertisement
ABC-600NS
condition (e.g., a short circuit) or an unsafe operating condition (e.g., a
voltage higher than the user-defined limit).
The following displays and controls are operable in manual mode or
through the ROS. The ABC-600NS starts up with both Channel A and
Channel B in manual mode. Both the Remote A and the Remote B buttons
are unlit in this mode. To toggle to remote operation, press the button for
the corresponding channel. Ensure that you have the ROS computer
operational and connected to the ABC-600NS and that the remote button
lights up (yellow).
CONFIGURATION
31565-03_01
Figure 2.3. DC Converter Front Panel
The ABC-600NS starts up in Independent mode as its
default.
To change this configuration, press either the
External Parallel buttons (yellow) to enable external parallel
operation or the RVS button (yellow) to enable RVS
(Remote Voltage Sensing) in either mode. If both buttons
are unlit, the unit is in default independent.
Page 14 of 51
Installation, Operation and Maintenance
Webasto Charging Systems, Inc.
Advertisement
Table of Contents
