Table of Contents
Advertisement
3. Personnel Requirements
A. Service and Maintenance Procedures in this Manual
(1) Personnel performing the service and maintenance procedures in this manual
are expected to have the required equipment/tooling, training, and certifications
(when required by the applicable Aviation Authority) to accomplish the work in
a safe and airworthy manner.
(2) Compliance to the applicable regulatory requirements established by the
Federal Aviation Administration (FAA) or international equivalent is mandatory
for anyone performing or accepting responsibility for the inspection and/or
repair of any Hartzell Propeller Inc. product.
(a) Maintenance records must be kept in accordance with the requirements
established by the Federal Aviation Administration (FAA) or international
equivalent.
(b) Refer to Federal Aviation Regulation (FAR) Part 43 for additional
information about general aviation maintenance requirements.
4. Special Tooling and Consumable Materials
A. Special Tooling
(1) Special tooling may be required for procedures in this manual. For further
tooling information, refer to Hartzell Propeller Inc. Illustrated Tool and
Equipment Manual 165A (61-00-65).
(a) Tooling reference numbers appear with the prefix "TE" directly following
the tool name to which they apply. For example, a template that is
reference number 133 will appear as: template TE133.
B. Consumable Materials
(1) Consumable materials are referenced in certain sections throughout this
manual. Specific approved materials are listed in the Consumable Materials
chapter of Hartzell Propeller Inc. Standard Practices Manual 202A (61-01-02).
(a) Consumable material reference numbers appear with the prefix "CM"
directly following the material to which they apply. For example, an
adhesive that is reference number 16 will appear as: adhesive CM16.
Only the material(s) specified can be used.
HARTZELL PROPELLER OVERHAUL MANUAL
(Rev. 1)
144
(Rev. 1)
61-10-44
INTRODUCTION
Page 6
Rev. 5 Apr/23
Advertisement
Chapters
Table of Contents
