Section C: Removing & Installing Slides; Section D: Opening Top Chest Drawers - Kobalt 0827414 Manual

Section C: Removing & Installing Slides
To remove the slide from the unit, first
remove the drawer.
After removing the drawer, check to see if
the unit has rivets located on the front of
the slide. To drill out rivets, use a 5/32-in.
drill bit. The rivets will need to be replaced
with 5/32-in. rivets.
To reinstall the slide in the appropriate
position in the unit, align front and back
lances with mounting holes in the side of
the unit. Pull toward the front of the unit
and downward until rivet holes in slide line
up with holes in the unit. The rivets will
need to be replaced with 5/32-in. rivets.
For smooth operation, make sure the
drawers are matched with their original
slides.

Section D: Opening Top Chest Drawers

Locate the drawer lock lever in the center,
back of the top chest open till area.
To unlock drawers move lever to the right,
resting it in the lock catch.
To lock drawers pull lever forward to re-
lease from lock catch, move lever to left to
lock.
Note: Drawers are only locked when the
lever is in the "locked" position. To secure
all the content in the top chest, lock draw-
ers with the lock lever, close lid, and lock
lid with key.
3
Drill out rivet
4
5
Unlocked position
in lock catch
kobalttools.com