Husqvarna 96041041200 Operator's Manual page 7

INSTALL SEAT (See Figs. 3 - 5)
• Remove bolts and winged washers se cur ing seat to
cardboard packing and set aside for as sem bly of seat
to tractor. Remove the cardboard packing and discard.
IMPORTANT: Do not remove tape from adjustment handle
until seat is properly secured to tractor.
• Connect wiring harness to the seat switch.
MIDDLE PAD
SEAT
SWITCH
FRONT PAD
FRONT SLOT
SEAT PAN
NOTE: All three pads will not install at the same time. The
middle pad must be installed first before other pads will
align with assembly holes.
• Place seat on seat pan so middle pad is aligned with
middle slot assembly hole.
• Insert pad and pull seat towards rear of tractor until
front two pads align with front slot assembly holes
• Insert pads by providing evenly distributed light down-
ward pressure and pull seat towards rear of tractor,
making sure front pads are engaged on the seat pan.
• Raise seat. Assemble bolts and winged washers and
tighten securely to front pads.
NOTE: Ensure "UP" reads right side up and arrow is point-
ing up on winged washers as shown.
SLOT
PAD
WINGED
WASHER
BOLTS
WINGED WASHER
• Remove tape and discard.
ASSEMBLY
TAPE
WIRING HARNESS
MIDDLE SLOT
Fig. 3
Fig. 4
TAPE
ADJUSTMENT
HANDLE
SEAT PAN
Fig. 5
WARNING: Ensure the seat assembly is securely
fastened to the seat pan before occupying or operating
tractor.
• Lower seat into operating position and sit on seat.
Press clutch/brake pedal all the way down. If operating
position is not comfortable, adjust seat.
TO ADJUST SEAT (See Fig. 3)
• Grasp adjustment handle and pull up. Slide seat to
desired position and release adjustment handle.
IMPORTANT: Before operating tractor, ensure operator
presence switch is functioning properly (see "CHECK
OPERATOR PRESENCE SYSTEM" in the MAINTENANCE
section of this manual).
TO INSTALL HOOD SCOOP (See Fig. 6)
7
Fig. 6