Table of Contents
Advertisement
le system control
soos as
aes
A
Connecting system control cords after connecting
a KENWOOD
audio component system lets you take advantage of
convenient system control operations.
There are two KENWOOD system control modes. Make connections according to the groups of terminal symbols shown
below.
X88 Made : lets you combine [XS XSB, and Xf terminals
(LTB) Mode : for (GLB) terminals only
This unit is compatible with both [XS8] and [SL16] modes. It comes from the factory set to the [SL16] mode. To switch to the [XS8] mode, follow
the instructions in "SWITCHING FROM [SL16] TO [XS8]" below.
EXAMPLE: [XS8] mode connections
EXAMPLE: [SL16] mode connections
The underlined portion represents the setting of the system control mode.
The underlined portion represents the setting of the system contro! mode
[SL16} (XSB)
Receiver
[SL16] IxS8]
[SL16]
MD recorder
[SL16}
MD recorder
[SL16][XSI[XS8][XR]
| Cassette deck
2onin5,
[SL16] [XS] [X$8] [XR]
Cassette deck | 25 GN,
[SL16] [XS] [X$8]
CD player
so
[SL16] [XS] [XS8]
CD player
-
[XS]
Record player
{X$]
Record player
* In order to take advantage of the system control operations, the components must be connected to the correct jacks. To use a CD player it must
be connected to the CD jacks. To use a cassette deck (or MD recorder) it must be connected to the TAPE1/MD jacks. When using more than one
CD player (etc.) only the one connected to the specified jacks may be connected for system control.
¢ Some CD players and cassette decks are not compatible with the [SL16] system control mode Be sure to use the [XS8] system control mode
when making system connections with equipment that is not [SL16] compatible.
«Some MD players are not system control compatible. You cannot make system control connections to this kind of equipment.
1. [SL16] equipment cannot be combined with [XR], [XS], and {XS8] equipment for system operations. If your
:
equipment consists of this kind of combination, please do not connect any system contro! cords. Even without
Ne,
gf
i
system control cords, normal operations can be carried out without effecting performance.
he —
{ [=
| (Notes)
2 Do not connect system control cords to any components other than those specified by KENWOOD.
It may
oe
Py
4
cause a malfunction and damage your equipment.
"es
we
3. Be sure tne system control plugs are inserted all the way in to the system contro! terminals.
i
recoraina from CD. MD or anaiog discs
then on once to confirm the new setting.
Registering setup codes for KENWOOD audio components
* Once you finish making the system connections, be sure to register the appropriate setup code for each component.
= 38.
Advertisement
Table of Contents
