Kenwood 106VR Instruction Manual page 16

.. ... . ''06Vn/105VR lEnl
When recording sound with a recorder component of KENWOOD, synchro recording is possible by setting the INPUT SELECTOR
to select TAPE1 or MD according to the connected component.
----
Preparation
• Switcn the VIDEOl display to TAPE) or MD wti^ the following
operation
Each press switches the display
f 1
1 VIDEOl
—
2 TAPEl 3 MD
O Select VIDEOl with the INPUT SELECTOR.
© Press and hold the AUTO key for more than 2 seconds.
\-
_-
To record a music source
Copying tape (Tape dubbing TAPE 2-*^ TAPE 1)
The input sources are switched in the following order,
♦
I TUNER
(frequency display)
2
PHONO
3
VIDE01
(TAPEl or MD)
4 CD
^
5 VIDE02
• The VIDEOl display can be switched to the display of other input by
using the procedure described in "Preparation" above
• For MD recording, refer to the instruction manual of your MD recorder
• It IS not possible theVIDEO! orMD input to TAPEl because all of these
components should use the same INPUT SELECTOR position.
Lignts
• For copying a tape using a double cassette deck, read the instruction
manual of the double cassette deck
Copying tape (Tape dubbing TAPE 1 TAPE 2)
O
Select TAPE 1 with the INPUT SELECTOR control of the
main unit.
© Play the cassette deck connected to the TAPE 1 jacks and
start recording of the cassette deck connected to the
TAPE 2 jacks.
Regarding TAPE2 MONITOR
A cassette deck or graphic equalizer can be connected to this unit's
TAPE 2 MONITOR
terminals. If you connect a graphic equalizer, turn the
TAPE 2 MONITOR
key ON If you connect a 3-head cassette deck, you can monitor the source sound, or the sound being recorded, while
recording. Pressing the
TAPE 2 MONITOR
key lets you compare the recorded sound and the source sound Refer to the operating manual
for the component you connected fcr further details