Toro 144-1620 Manual page 4

Figure 2
1. Existing traction plate
4. Remove the existing traction plate from the
friction wheel plate by removing the bolt holding
it in place (Figure
Figure 3
1. Traction plate bolt
5. Install the new traction plate on the friction wheel
plate using the previously removed bolt
4).
2. Spring
3).
2. Existing traction plate
(Figure
g340063
1. Traction plate bolt
6. In the rear of the machine, unhook the traction
cable from the traction-cable bracket
1. Traction rod
2. Traction-cable bracket
g340064
7. Unhook the traction rod from the traction-cable
bracket and slide the rod out the back of the
machine.
8. Remove the existing traction-cable bracket from
the crank bracket by removing the bolt and nut
holding it in place
2
Figure 4
2. New traction plate
(Figure
Figure 5
3. Traction cable
(Figure 6).
g340065
5).
g340066