Speaker Connections - Orion XTREME 800.4 2 Owner's Manual

SPEAKER CONNECTIONS
TRI-MODE 6-CHANNEL CONFIGURATION
• Lowest recommended impedance is 2 Ohm stereo and
4 Ohm bridged mono
• Front and rear outputs must be set for full range
operation (page 12)
• Front and rear outputs must be configured for stereo
operation (page 11)
• Passive crossover frequencies must not overlap.
WARNING! Failure to do so may result in damage to
the amplifier
-OO
4 Ohm Minimum 4 Ohm Minimum
page 24
INSTALLATION TIPS
The installation of all ORION components will determine the overall performance result. Improper installation will not only limit the perfor¬
mance of your ORION system but also potentially compromise the reliability of this amplifier. To ensure proper sonic results and component
reliability, please refer to your Authorized ORION dealer for installation assistance or advice. If you decide to perform the installation yourself,
read the entire installation section of this manual before beginning installation.
TOOLS OF THE TRADE
Listed are the majority of the tools required to perform the installation,
of these tools are necessities. Some make the job much easier.
• marking pen
• electric drill with assorted drill bits
• utility knife
• Phillips and flat blade screw drivers
• pliers (standard and needle nose)
• wire brush or sandpaper for chassis grounding
• solder iron and solder
Having the proper tools will make the installation much easier. Some
• heat shrink tubing
• nylon tie straps
• volt-ohm meter (optional)
• wire cutters
• wire crimpers
• wire strippers
page 25