Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Wisdom SW-1DSP
Summary of Contents for Wisdom SW-1DSP
- Page 1 Owner’s Manual SW-1DSP Subwoofer Amplifier with Digital Signal Processing...
-
Page 2: Table Of Contents
DOCUMENT CONVENTIONS This document contains general safety, installation, and operation instructions for the Wisdom Audio SW-1DSP Subwoofer Amplifier. It is important to read this document before attempting to use this product. Pay particular attention to: WARNING: Calls attention to a procedure, practice, condition or the like that, if not correctly performed or adhered to, could result in injury or death. - Page 3 Increase the separation between the equipment and the receiver • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected • Consult the dealer or an experienced radio/TV technician for help SW-1DSP WISDOMAUDIO.COM...
-
Page 4: Safety Instructions
Important Safety Instructions Please read all instructions and precautions carefully and completely before operating your Wisdom Audio equipment. 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this equipment near water. -
Page 5: Unpacking The Sw-1Dsp
SW-1DSP, so all cables have sufficient room to bend without crimping or undue strain. If possible, the SW-1DSP should also be placed in such a way that the power switch on the rear panel is easily accessible. This switch disconnects power from the unit completely, resulting in effective disconnection of the SW-1DSP from the AC mains. -
Page 6: Operating Voltage
High Efficiency – While many contemporary amplifiers waste 50% or more of the power they pull from the wall as heat, your SW-1DSP amplifier runs at approximately 90% efficiency. As a result, more power is available for the loudspeaker, and less is wasted as heat in your room. -
Page 7: Front Panel
1. SYSTEM STANDBY LED (Amber Color) AMBER LED will be illuminated when in standby and not processing audio. 2. AUDIO POWER LED (Blue Color) BLUE LED will be illuminated when the SW-1DSP is processing audio and the amplifier is active. Power Mode Display SYSTEM AMBER... -
Page 8: Rear Panel
These audio inputs normally accept the subwoofer output signals from the system’s Surround processor. If two inputs are connected, they will be summed and amplified as a single channel. Connect the appropriate outputs of the SW-1DSP to this input, using a high-quality audio cable. - Page 9 The 12V Trigger Output jack is driven to a “high” state of 12 volts a few seconds after the SW-1DSP is turned on and can source as much as 100 mA of current at 12 volts. This signal may be used in turn to control other components, such as additional Wisdom...
- Page 10 [2] Connecting the SW-1DSP on a Local Area Network using IP Address If the SW-1DSP cannot be located using mDNS, it can be accessed via IP address. First locate the IP address of the SW-1DSP by performing an IP scan of the network using a scanner such as the Advanced IP Scanner.
- Page 11 If the above methods do not work, you can connect directly without a router or switch. The SW-1DSP will have a default IP Address of 169.254.0.8 if no DHCP router is found. This can happen if you are using a switch only, or have connected directly from your computer to the SW-1DSP.
- Page 12 Standby is with the DC Trigger (above). An AC mains switch is located adjacent to the power cord on the rear panel of the SW-1DSP. This switch may be used to disconnect the unit from the AC mains without having to unplug the SW-1DSP from the wall outlet.
-
Page 13: Care & Maintenance
The Wisdom Audio SW-1DSP incorporates a fuse block that protects both the live and neutral (ground) sides of the circuit. If your SW-1DSP is plugged into an AC outlet that you know is live (plug a lamp into it as a test), and yet appears to be off, check the following: 1. -
Page 14: North American Warranty
The warranty will not apply to any Wisdom Audio products that has been misused, abused, altered, or installed and calibrated by anyone other than an authorized Wisdom Audio dealer. -
Page 15: Obtaining Service
Wisdom Audio for further service information or parts, or to obtain a Return Authorization. The Wisdom Audio Service Department works closely with your dealer to solve your service needs expediently. -
Page 16: Specifications
• Product Dimensions HxWxD: 1.7” x 17” x 11.29” (43mm x 432mm x 287mm) • Shipping Weight: 12 lbs. (5.5 kg) • Shipping Dimensions: TBD For more information, see your Wisdom Audio dealer or contact: Wisdom Audio 1572 College Parkway, Suite 164 Carson City, NV 89706 wisdomaudio.com... -
Page 17: Dimensions
SW-1DSP Dimensions SW-1DSP WISDOMAUDIO.COM... - Page 18 WISDOM and the stylized W are registered trademarks of Wisdom Audio. Wisdom Audio 1572 College Parkway, Suite 164 Carson City, Nevada 89706 USA (775) 887-8850 (775) 887-8820 wisdomaudio.com SW-1DSP OM © 12/2023 Wisdom Audio, Inc. All rights reserved. Printed in U.S.A. SW-1DSP WISDOMAUDIO.COM...
Need help?
Do you have a question about the SW-1DSP and is the answer not in the manual?
Questions and answers