Connecting The Drain Hose - LG SWW 50 Series Owner's Manual

24 INSTALLATION
Required Accessories
Hot and Cold Water Hoses (for Washer)
a
Cold Water Hose (for Dryer)
b
Connecting Supply Hose
c
Tie Straps
d
1
Check the fittings and seals. Inspect the
threaded fitting on each hose and make sure
there is a rubber seal
of each hose to prevent leaking.
2
Connect the Y connector
. Connect the 2 blue hoses
g
connector.
3
Connect the water supply hoses.
• Connect the water inlet hoses to the hot
and cold water faucets tightly by hand and
then tighten another 2/3 turn with pliers.
• Connect the short blue hose to the cold
water faucet and the red hose to the hot
water faucet.
in place in both ends
e
to the short hose
f
to the Y
h
4
Flush out the inlet hoses.
• After the hoses are connected, turn on the
water faucets and flush out any foreign
substances such as dirt, sand, or sawdust.
• Let the water drain into a bucket, and check
the water temperature to make sure you've
connected the hoses to the correct faucets.
5
Attach the inlet hoses to the back of the
appliance and secure the cold water inlet
hoses with tie straps
For the Washer
• Attach the hot water inlet hose
water inlet on the back of the washer.
Attach a cold water inlet hose
water inlet on the back of the washer.
For the Dryer
• Attach a cold water inlet hose
water inlet on the back of the dryer.
• Tighten the fittings securely. Turn on both
faucets all the way and check for leaks at
both ends of the hoses.

Connecting the Drain Hose

Connect the drain hose to either a standpipe or
laundry tub.
.
k
to the hot
i
to the cold
j
to the cold
j