LG SWW 50 Series Owner's Manual page 55

Problem
Water supply Water supply pressure to faucet or house is too low.
• Check another faucet in the house to make sure that household water pressure is
• Disconnect the water inlet hoses from the washer and run a few gallons of water through
• If flow is too low, contact a plumber to have the water supply lines repaired.
Water supply connected with leak-limiting hoses.
• The use of hoses designed to limit leaks is not recommended. Leak limiting hoses can trip
Drainage Drain hose is kinked, pinched, or clogged.
• Make sure that the drain hose is free of clogs or kinks and is not pinched behind or under
The end of the drain hose is more than 96 inches (2.4 m) above the bottom of the
washer.
• Move the end of the drain hose so that it is lower than 96 inches (2.4 m). For best
Unbalance The load is too small.
• Add additional items to allow the washer to balance the load.
Heavy articles are mixed with lighter items.
• Always try to wash articles of somewhat similar weight to allow the washer to evenly
The load is out of balance.
• Manually redistribute the load if articles have become tangled, preventing the automatic
No water detected The water level sensor is not working correctly.
• Close the water faucets, unplug the washer, and call for service.
Motor error A motor error has occurred.
• Allow the washer to stand for 30 minutes and then restart the cycle.
• If the error code is still displayed, call for service.
Water too high Water level is too high due to a faulty water valve.
• Close the water faucets, unplug the washer, and call for service.
Freeze error Inlet hose, drain hose or drain pump is frozen.
• See Care in Cold Climates.
No temp detected Control error.
• Unplug the washer and wait 60 minutes. Reconnect power and try again.
• If the error code is still displayed, call for service.
Vibration sensor Vibration sensor is malfunctioning.
• Call for service.
Turbidity sensor Turbidity sensor is malfunctioning.
• Call for service.
Power failure There was a power interruption or the power cord was not properly plugged in.
• Plug in the power cord or press the Start/Pause button to restart the cycle.
Oversudsing Too much detergent was used.
• Do not add more than the recommended amount of detergent.
adequate and flow is not restricted.
the hoses to flush out any dirt.
falsely and prevent the washer from filling.
the washer.
performance, the end of the drain hose should be no higher than 66 inches (168 cm).
distribute the weight of the load for spinning.
rebalancing from working properly.
Possible Cause & Solution
TROUBLESHOOTING 55