Advertisement
Table of Contents
Table of Contents.......................... 2
Safety Information........................ 2
Pre-Installation.............................. 3
Planning Installation...................... 3
Specifications................................... 3
Tools Required................................. 3
Hardware Included......................... 4
Safety Information
IMPORTANT
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE NA-
TIONAL ELECTRICAL CODE AND LOCAL BUILDING CODES BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED.
PRECAUTIONS
☐ Please read and understand this entire
manual before attempting to assemble,
install, or operate this light fixture.
☐ This light fixture requires a 120-Volt AC
power source.
☐ Some codes require installation by a
qualified electrician.
☐ This light fixture must be properly
grounded.
☐ Make sure connections are secure using
wire nuts, crimp-on lugs or other ap-
proved connecting devices
☐ This light fixture should be installed
outdoors to a wall or eave.
☐ This product may contain chemicals
known to be hazardous. Thoroughly
wash hands after installing, handling,
cleaning or otherwise touching the
product.
INFORMATION: The device is tested and found to comply with Part 15 of the FCC Rules. Operation is subject
to two conditions: (1) This device may not cause harmful interference and, (2) this device must accept any
interference received, including any interference that may cause undesired operation.
These limits are designed to provide reasonable protections against harmful interference when the equip-
ment is operated in a commercial environment.
Visit www.probrite.com/install for installation video tutorials and product support
Package Contents.......................... 4
Installation...................................... 5
Operation ....................................... 8
Care & Cleaning............................. 9
Troubleshooting............................ 9
Warranty........................................ 10
WARNING: Turn the power off at the circuit
breaker or fuse. Place tape over the circuit
breaker switch and verify power is off at the
light fixture.
WARNING: Risk of fire. Keep the lamp heads at
least 3 in. (76mm) from combustible materials.
CAUTION: Burn hazard. Allow the light fixture
to cool before touching.
NOTICE: Do not connect this fixture to a
dimmer switch.
NOTICE: FCC Regulations state that any
unauthorized changes or modifications to
this equipment not expressly approved by the
manufacturer could void the user's authoriza-
tion to operate this equipment.
2
Pre-Installation
PLANNING INSTALLATION
Before installing the light fixture, ensure that all parts are present. Compare parts with the
Hardware Included and Package Contents sections. If any part is missing or damaged, do
not attempt to assemble, install, or operate this light fixture.
Estimated installation time: 15 minutes
SPECIFICATIONS
Lumens (Light Output)
Watts (Power Consumption)
Replaces
Lumens/Watts (Efficacy)
Power Requirements (Input Voltage)
Light Color (CCT)
Dimmable
Operating Modes
TOOLS REQUIRED
Phillips
Wire strippers/
Screwdriver
cutters
Silicone
Sealant
Safety
goggles
Please call 1-844-507-5651 or email support@probrite.com for further assistance.
1400 Lumens
20 Watts LED
100 Watt Incandescent Bulbs
70 lumens per watt
120VAC, 60 Hz
3000 Kelvins (Warm White)
Non-Dimming (Do not wire to dimming switch)
Switch-Controlled:
Flip switch to turn light fixture ON and OFF.
Use external photocell light sensor, timer or
motion sensor for automatic functionality
(sold separately)
Circuit tester
Ladder
Work
gloves
3
PROBRITE.COM
Advertisement
