Advertisement
Installation (continued)
7
Mounting the light
fixture
☐ Once the fixture is wired, place the light
fixture (A) onto the mounting plate (C)
so the top sloped grove on the plate
rests on the top sloped grove on the
back of the fixture.
☐ Tighten the mounting plate by tighten-
ing bolt (B) back through the hole on
the bottom of the fixture (A) until the
bolt firmly pushes against the mounting
plate (C).
C
B
A
CC
Operation
SWITCH-CONTROLLED
Switch-controlled operation enables the light fixture to turn ON and OFF
by flipping a standard light switch. To add automatic Dusk to Dawn control
or motion sensing external sensors like a photo-control, motion-sensor or
timer is required (sold separately).
☐ Once the fixture is installed, turn power
back on from the circuit breaker and
switch.
☐ Flip switch ON and OFF to ensure light
functions properly.
NOTE: This fixture is not dimmable, so it
is best to not wire to a dimming switch.
Visit www.probrite.com/install for installation video tutorials and product support
8
Caulking around the
light fixture
☐ Caulk around the mounting plate (C)
and surface with silicone sealant (not
included).
C
NOTICE: Failure to properly caulk around the
surface and mounting plate (C) could lead
to water damage and is not covered under
warranty.
NOTE: When attaching this fixture (A) to an
external, surface mount junction box, caulk the
inside of the light fixture before attaching to the
mounting plate (C).
SWITCH
CONTROLLED
8
Care and Cleaning
☐ Shut off main power supply before cleaning the product. To prolong the original ap-
pearance, clean the light fixture with clear water and a soft, damp cloth only.
☐ Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints,
solvents, or any other chemicals on this light fixture. They could cause a premature
deterioration of the finish and may void the warranty.
☐ Do not spray the light fixture with a hose or power washer.
Troubleshooting
If Light does not come on:
☐ Verify that the power is turned ON from the circuit breaker and wall switch.
☐ Verify the wiring for the fixture is done properly.
☐ Verify the line voltage is correct.
If Light flickers:
☐ Do not wire to a dimming switch, use a standard ON/OFF switch
Please call 1-844-507-5651 or email support@probrite.com for further assistance.
9
PROBRITE.COM
Advertisement
