Table of Contents
Advertisement
Status light
The status light at the bottom on the dishwasher provides information by means of 3 different colors.
Status light
Blue - Load more
The program has started, but you can still load more dishes.
Red - Do not load
You should not load more dishes (can result in poor dishwashing).
A flashing light indicates that the door has been opened while a program is in progress. If it flashes
when the door is closed, an error has occurred. See the chapter Troubleshooting.
Green - Unload
The dishwashing program is finished. The status light stays on for 30 minutes.
If you want to load more dishes
Open the door. The dishwasher stops automatically. Add the dishes. Press
within four seconds.
WARNING!
If the door is open, "Program paused" is shown on the display. If you want the dishwashing
program to continue, press
dishwashing program, press and hold
Power failure
If the dishwasher is turned off due to a power failure when a dishwashing program is running, the
program continues when power is restored. If the power is lost during drying, the program is
interrupted.
If you open the door for more than 2 minutes during drying, the program will be interrupted.
Once the program has finished
The end of the program is indicated by one short signal from the buzzer. The chapter Settings
describes how to change this function.
Moreover, the end of the program is indicated by the status light turning green.
4)
You should not load more dishes if the status light is red.
4)
and close the door immediately. If you want to cancel the
for three seconds.
Using the dishwasher
and close the door
21
Advertisement
Table of Contents
