Sym JET 14 XC05W1-EU Series Owner's Manual page 17

§DISK BRAKE INSPECTION§(
（leak, damaged, looseness of brake line）
(Checking front brake lining)

check the brake from behind the brake
caliper. The brake pad must be replaced
with new lining when the brake pad wear
limit reaches the brake disk.
Brake caliper
(Replenishment of front wheel brake fluid)
1.Loosen the screws and remove the master cylinder cover.
2.Wipe clean foreign materials, dirt around the reservoir, being
careful not to let foreign materials fall into the reservoir.
3. Remove the diaphragm plate and the diaphragm.
4. Add brake fluid to upper lever.
5.Install the diaphragm plate and the diaphragm, and install the
master cylinder cover.
6.please note the diaphragm direction, and do not let foreign
materials fall into the reservoir. And tighten the master
cylinder cover securely.
CAUTION:
 To prevent chemical reaction, please do not use brake fluids other than those recommended.
 Do not fill above the upper limit when adding brake fluid and avoid dropping on painting or
plastic components to prevent damage.
Applicable for model equipped with disc brake.
Brake pad wear
limit grooves
Brake disk
 Visual check brake lines for leakage, or damage, check
brake lines connections for looseness using a wrench or
similar tool, and check whether steering handle vibration in
driving, or any parts' interference may have damage the
brake lines. If so, bring your scooter to your SANYANG
dealer for repairing or service.
CAUTION:
 Please drive your motorcycle on a dry road
surface slowly and operate front and rear brakes
in order to find out if there is any malfunction so
as to ensure the motorcycle is at optimum
condition and safe ride.

(Checking oil quantity in brake oil reservoir)
 .

Park the scooter on a lever ground, and
check if fluid lever is under the "LOWER"
mark. Recommended Brake Fluid: WELL
RUN BRAKE OIL (DOT 3).
Master cylinder
cover
Diaphragm
16
)
Screw
Upper
Brake fluid