Ditel SXT48S Quick Installation Manual

QUICK INSTALLATION GUIDE
AUTO-TUNE PID
TEMPERATURE CONTROLLER
WITH CONTROL RELAY / SSR
Installation and use of this device must be done by qualified, authorized and trained technical personnel only.
Inspect device carefully before installation. Do not install and use broken and defective devices.
Do not disassemble device. Do not make any repair on any part of the device. There is no accessible part inside the
device. Please contact to manufacturer for broken and defective devices.
Do not use device in environments subject to flammable, explosive and corrosive gases and/or substances.
This device is designed for applications only in light industrial environments. This device is not suitable for medical
and residential use. This device is not suitable for use related with human health and safety. This device is not suita-
ble for automotive, military and marine use.
Do not allow children and unauthorized people to use this device.
Before installation and any technical work, disconnect the power supply and mains connections.
Check the power supply voltage level before power on, and make sure voltage level is in specified limits.
Check quality of neutral line. Improper neutral line may give permanent damage to the device.
Connect an external power switch and an external fuse (1A, 250VAC) to the power supply line that are easily acces-
sible for rapid intervention. Connect an external fuse (2A, 250VAC) for each relay output separately.
Use appropriate cables for power supply and mains connections. Apply safety regulations during installation.
Install the device in a well ventilated place. Install the device permanently into a proper panel cut-out. Fix the device
with two fasteners supplied with the device. Only front panel must be accessible after installation is completed.
Do not operate the device other then the environmental conditions given in Technical Specification.
GENERAL SPECIFICATION
WARNINGS
DOWNLOAD
USER MANUAL
SXT48S