Advertisement
MK-100
Disassembly and Replacement
The
MK-100
which
features
an ultra-compact design and high performance
uses miniature-sized
parts which
are closely
arranged. Use special care when servicing it.
Enclosure
Parts Name
Procedure
Ref. No.
Description
Bottom panel
Remove
four
mounting
screws
and
then
remove
the bottom
Fig. 3 @)
SPSK2003M
(Black)
panel.
SPSK2003N (Silver)
5 eerie
Top panel
Remove five screws and then remove the top panel.
Fig. 2,3 @) | SPSK2003M(Black)
SPSK2003N (Silver)
=
Front panel
1. Pull out the control knob.
2. Remove two screws and then remove the front panel.
Fig. 2 @)
SPSK2003M (Black)
Rear panel
1. Remove two screws.
Fig.3
@
SPSK2003M (Black)
2. Remove one screw and pull out the security strap.
Fig.3
®
SPSK2004M (Black)
3. Then remove the rear panel.
=
Inner-lay and
. Remove
four screws
and then remove the cassette
lid ass'y.
Fig. 4 ©
SPSK2003M (Black)
cassette lid
2. Then put out the hinge shaft.
SPSK2003N (Silver)
Note: When disassembling the panel, take care not to scratch it.
Electric parts
Parts Name
Procedure
Description
Circuit board
1. Remove the bottom panel, front panel, control knob, top panel
See 'Enclosure' sec-
and rear panel.
tion.
2. Then remove three screws.
SPSK2004N
Note: When removing the circuit board, if you set the circuit
board up by a screw-driver keeping the leaf switch away
from the F.F. button, removing is very easy.
. Remove seven wires and one diode soldered to circuit board.
Then remove circuit board ass'y.
When
installing the circuit board, please install it after the
slide
switch
for PLAY/RECORD
is switched
over
to the
play position.
Sub-board
Remove one screw and raise the sub-board.
F004 10-235M
No. 0002
Advertisement
