Advertisement
OM-CP-PRTRANSIS-A2
Installation Guide
Installing the software
Insert the Omega Software Flash Drive in an open USB port. If the autorun does not appear, locate the drive on
the computer and double click on Autorun.exe. Follow the instructions provided in the Installation Wizard.
Installing the Interface cable
- OM-CP-IFC200 (required, sold separately)
Insert the device into a USB port. The drivers will install automatically.
Device Operation
Starting the data logger
- Once the software is installed and running, plug the interface cable into the data logger.
- Connect the USB end of the interface cable into an open USB port on the computer.
- The device will appear in the Connected Devices list, highlight the desired data logger.
- For most applications, select "Custom Start" from the menu bar and choose the desired start method,
reading rate and other parameters appropriate for the data logging application and click "Start". ("Quick
Start" applies the most recent custom start options, "Batch Start" is used for managing multiple loggers at
once, "Real Time Start" stores the dataset as it records while connected to the logger.)
- The status of the device will change to "Running", "Waiting to Start" or "Waiting to Manual Start",
depending upon your start method.
- Disconnect the data logger from the interface cable and place it in the environment to measure.
Note: The device will stop recording data when the end of memory is reached or the device is stopped. At this point
the device cannot be restarted until it has been re-armed by the computer.
Downloading data from a data logger
- Connect the logger to the interface cable.
- Highlight the data logger in the Connected Devices list. Click "Stop" on the menu bar.
- Once the data logger is stopped, with the logger highlighted, click "Download".
- Downloading will offload and save all the recorded data to the PC.
Advertisement
