Table of Contents
Advertisement
XR-MT3
7
Assembly of Drawer and Chassis
The following work is done before Drawer is put on Chassis.
(1) It is confirmed that Carriage 300 is clamped, and Clamper has
fallen.
(2) It is confirmed to Drawer to be built in neatly in order of Carriage
200 and 100.
(3) Arm Stopper B is moved horizontally (inside) as shown in the
figure below.
A
(4) Pulls Slider 2 until the lock comes off to the direction of ta front
side.
B
Note : Do not lift Arm Stopper B for above when you move Arm
Stopper B.
There is a possibility to bend the spring when Arm Stopper B
is lifted, and the spring bends. And, when Arm Stopper B
becomes floatage feeling, Drawer is caught.
Arm
Stopper
B
Slider 2
Coming off of
a black gear
is noted.
Direction of front
1
This
part of Drawer is put on Chassis like the arrow.
Chassis
2
The lac teeth and Gear Idler A are matched, and it is pressed
under the diagonal lightly.
3
Right this side of Drawer is lifted.
4
Drawer is moved back and forth, and stops Drawer with the
point which it enters left.
52
Coming off
in the spring
is noted.
A
The lock
comes off.
B
10mm is opened.
Drawer
1
5
Its right side is slowly lowered up to the angle by which Bevel
Gear can do in the slide while doing Drawer back and forth by
about 5mm.
2
Lac teeth
Gear Idler A (black)
6
When peeps from the inside of Drawer when the receiving part
of Gear is fixed into the concave part of Bevel Gear, the place
where it is fixed is comprehensible.
6
Concave of Bevel Gear
8
4
3
5
Bevel Gear
Drawer
Receiving
part of Gear
7
Chassis hook
Advertisement
Table of Contents
