Table of Contents
Advertisement
•
3
Notes of procedure
.
FRONT side
4-1
The other side of the side applied by
pushed.
4-2
Puts Carriage 100 on Carriage 200 which applies by
Be careful about notes by
Bevel Gear is turned clockwise.
5
(direction of a rear side from a front side)
5
6
6-1
Carriage 200 moves to a front side.
6-2
Bevel Gear is turned as it is clockwise.
(direction of a rear side from a front side)
6-3
Carriage 100 drops below.
Hang Carriage only here of Pinion.
4
Carriage 200
3
of Carriage is lightly
4-1
at this time.
3
9
7
Carriage 200 is lightly
lifted by the finger.
7
When Carriage 100 drops below, Carriage 200 is lightly lifted
by the finger.
Note : Lift it horizontally when you lift Carriage.
Carriage inclines when it is not the horizontal, and
mechanism locks.
8
Bevel Gear is turned clockwise (direction of a rear side from
a front side) like the state of
9
Carriage 200 lifts up. And, when the movement is started
Carriage 100 to the direction of a front side, separates the hand
which lifted Carriage 200.
10
Keeps turning Bevel Gear clockwise (direction of a rear side
from a front side) until Carriage 100 bumps to the wall on
a front side.
.
The position of a right and left, black cam is matched while
11
confirming it from the table side of Drawer.
Meanwhile, Mark of right and left,
black Cam is matched.
Cam Mark
XR-MT3
8
9
,
.
7
Carriage 100
Surface of Drawer
11
Cam Mark
51
Advertisement
Table of Contents
