LG 70UQ81006LB User Manual page 120

I cannot turn on the TV.
Check that the power Standby Light on the TV is red. If the Standby Light is off, check
the connection of the TV power plug, as shown below.
If you are using a multi-outlet, check if it is working properly. To check whether a power
strip is working properly, plug the TV's power plug directly to a wall outlet and observe its
operation.
Try to power on using the button on your TV set.
The power is on, but the screen comes on later.
This is because there is a noise-removal process to eliminate any possible noise that
may appear during power-on. This does not mean the product is defective.
The pointer of Magic Remote is not appear in the screen.
Hold the remote control towards the TV and press the and buttons at the same
time for more than 5 seconds until instructions appear. The previously registered remote
control is deregistered and then registered again.
Replace the batteries when you are prompted to do so on your TV screen. (Use alkaline
batteries.)
General Accessibility Audio Guidance On
If is set to , the pointer of the
Magic Remote does not appear. Set Audio Guidance to Off . (Some models may not be
supported.)
I cannot turn the TV on with the remote control.
Please make sure your TV power plug is correctly connected to the outlet.
Replace the batteries in the remote control. (Use alkaline batteries.)
Check if there is an obstacle blocking the signal in front of the TV's remote control
receiver. If there is an obstacle, such as a soundbar, in front of the receiver at the bottom
of the TV, it may interfere with the remote control signal reception.
When using a set-top box remote control, if the TV integrated control function of the set-
top box remote control is turned off, you cannot power on or off the TV with the set-top
box remote control. Please contact your set-top box provider.
The power turns off suddenly.
Check if Power Off Timer is set.
The TV will be turned off automatically if you do not press any buttons for 4 hours even
120