RESEARCH CONCEPTS RC2K90INT-1 Manual page 19

Rc2000 antenna interface box
Table of Contents

Advertisement

Quan
Model/Description
1
240 Ohm, 1 Watt
5
150626 Connector
9
150646 Connector
2
Z320LA15A
2
7105U15SYZ3QE
1 or 2
KBPB-125 or KBPB-225
2
6-32 x 3/8" Screw
2
#6 Lockwasher
2
6-32 Small Outline Nut
4
??" Standoff
4
?? Nut w/ Nylon Insert
4
?? Screw
2 or 4
?? Screw
2 or 4
?? Washer
2 or 4
?? Lock Washer
2 or 4
?? Nut
1
1414 PHL6LP
1
1418 N4D8
4
Insulated Ring Terminal
Notes
1
2 are used for the RC2K90INT-1, 4 are used for the RC2K90INT-2
2
Only one motor drive module is used for the RC2K90INT-1, two motor drives are used for the
RC2K90INT-2.
3
When a KBPB-225 motor drive module is used with a 90 volt DC motor the KBPB should be
modified as described in Section 4.4.4. It is not necessary to perform this modification on new
Interface Boxes if 220/240 VAC line voltage and 90 volt DC motors are specified when the interface
box is ordered (the modification is performed at the factory).
4
12x12x6 box used up to 3/4HP 115VAC or up to 1 ½ HP 230VAC systems. The 20x20x8 box is
used up to 1 1/2HP 115VAC or up to 3 HP 230VAC systems.
Manufacturer
Comments (Ref Designators)
Resistor (R6)
Weidmuller
2 Position Screw Terminal Connector
Weidmuller
3 Position Screw Terminal Connector
CKE
320 Volt Metal Oxide Varistor (MOV1,
MOV2)
C & K
SPDT (MOM-OFF-MOM) Switch (SW1, SW2)
KB Electronics,
DC Motor Drive Module, the KBPB-125 is
Inc.
used with 120 VAC Versions of the Interface
Box, the KBPB-225 is used with 220/240 VAC
Versions of the Interface Box [2] [3]
Phillips Head Screw for Latching Relay Socket
Lockwasher for Latching Relay Screw
Nut for Latching Relay Screw
Circuit Board is Mounted on These Standoffs
For Use with Standoff
Connects Standoff to the Mounting Panel
KBPB Mounting Screw [1]
Used with KBPB Mounting Screw [1]
Used with KBPB Mounting Screw [1]
Used with KBPB Mounting Screw [1]
Hammond Mfg.
12" x 12" x 6" NEMA 4 Enclosure with
Panel[4]
Hammond Mfg.
20"x20"x8" NEMA4 Encl. w/Panel [4]
Crimp Type, #10 Stud, 10-12 AWG Wire Size -
Used for Motor and KBPB Chassis Ground
Connection
19
RC2000 Antenna Controller Interface Box

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rc2k90int-2Rc2kint

Table of Contents