Table of Contents
Advertisement
RS232 Port and RS232 Cable: Provides hardware status monitoring to industrial control system or IPC via
RS232. If more information are required, please contact supporting@raidon.com.tw.
※ Note :
1. We do not recommend users to disassemble the device without proper instructions and authorization. The manufacture
warranty will not cover the damages caused by unauthorized disassembling.
2. To prevent the device from malfunction, please make sure the device is connected with a direct and dedicated power
connection of a stable power input.
5. After unlocking the HDD tray key lock with the key attached to the accessory, push the HDD
tray ejection to the right and the removable drive tray will pop open to remove the removable
tray.
5. RAID Mode Setting
After placing your two hard disks, turn on power and press UP Button, you are with the RAID Setting
mode. (Since the default setting is RAID 1 mode by factory, you do not have to reset RAID if you
want to use your iR2823 / iR2824 with RAID 1 mode.)
1. RAID 1 mode
1). Place two new hard drives into iR2823/iR2824.
We would strongly suggest you to use two identical hard drives to get the maximum memory
capacity. And if the capacities of your two hard drives are difference, iR2823 / iR2824 only
recognizes the memory capacity at the small capacity hard drive.
2). Under RAID 1 mode, two hard drives will have the identical information as one from its mirroring
feature, therefore, even though one and only one of the two hard drives failed, iR2823 / iR2824
will still work fine and properly. Once you replace the failed hard disk with a new one, iR2823 /
iR2824 will automatically do rebuilding the data from the good one to the new hard disk.
Power Supply
1
SATA Cable
2
SATA Power Cable
iR2823 & iR2824
SATA Ports
Internal host shell schematic
4
iR2823 / iR2824 User Manual
iR2823/iR2824
Advertisement
Table of Contents
