Recording Over Existing Tracks; Adjusting The Recording Level - Sony MDS-E55 Operating Instructions Manual

Recording on MDs
ba a Pa a |
Recording Over Existing Tracks § Adjusting the Recording Level
Follow the procedure below to record over existing When recording with INPUT at ANALOG and the
material just as you would on an analog cassette tape. signal input through LINE (ANALOG) IN jacks, use
REC LEVEL to adjust the recording level before
starting recording.
Kil AMS DD You cannot adjust the recording level during digital
recording.
REC LEVEL
——— a ae ©:
—! = MELEE) o®
ooo
emo $8
©®
1 Do Steps 1 to 6 in "Recording on an MD" on
1 DoSteps 1 to 5 in "Recording on an MD" on page pages 6 and 7.
6.
2 Play the portion of the program source with the
y thep progr
2 Tum AMS (or press <q or PPI) until the strongest signal level.
number of the track to be recorded over appears.
3 While monitoring the sound, turn REC LEVEL to
3 Torecord from the start of the track, continue adjust the recording level so that the peak level
from Step 6 in "Recording on an MD" on page 7. meters reach their highest point without turning
on the OVER indication. Occasional lighting of
cer While "TRACK" flashes in the display SVERCpeccep able:
The deck is recording over an existing track, and stops
flashing when it reaches the end of the recorded
portion.
coy To record from the middle of the track
1 After Step 2 above, press E> to start playback.
2 Press If where you want to start recording.
3 Continue from Step 6 in "Recording on an MD" on
page 7.
Note 4 Stop playing the program source.
You cannot record from the middle of an existing track when
the "PROGRAM" or "SHUFFLE?" is on.
5 Tostart recording, do the procedure starting from
Step 8 in "Recording on an MD" on page 7.
118