Jandy TruSense TRUSENSE Owner's Manual page 15

Jandy TruSense Water Chemistry Analyzer | Owner's Manual
®
Figure 7. Submerge sensor & start calibration
11. Remove the pH sensor from storage tube and rinse the tip with clean
water.
12. Shake pH sensor to remove residual water. Partially insert the pH
sensor back into Jandy TruSense, see figure 8. DO NOT put sensor on
the ground or touch the glass tube.
Figure 8. Partially insert
13. Remove pH 7 buffer solution from storage tube.
a
Page 15
ENGLISH
Calibrate pH