Related Manuals for Bromic Heating BB0120GD-NR
Summary of Contents for Bromic Heating BB0120GD-NR
- Page 1 Confidence and control. INSTRUCTION MANUAL Back Bar Display Fridges 3736070-1, 3736071-1, 3736073-1, 3736072-1, 3736074-1 REVISION 1 | 10/07/2023...
-
Page 3: Table Of Contents
CONTENTS 1. PREFIX 2. IMPORTANT NOTES & WARNINGS 3. PRODUCT OVERVIEW 4. INSTALLATION 5. OPERATION 6. PRODUCT LOADING AND STORAGE 7. MAINTENANCE 8. TROUBLESHOOTING 9. ENVIRONMENTAL & DISPOSAL NOTES 10. WARRANTY Note: Bromic Refrigeration reserves the right to make changes to specifications, parts, components and equipment without prior notification. This Installation, operation and service manual may not be reproduced in any form with prior written consent from Bromic Refrigeration. -
Page 4: Prefix
1. PREFIX This manual contains important information about the installation, operation, and maintenance of Bromic Back Bar cabinets. Please pay close attention to the important safety information shown throughout this instruction manual. Any safety information will be accompanied by the following safety alert symbols: DANGER, WARNING,... -
Page 5: Important Notes & Warnings
2. IMPORTANT NOTES AND WARNINGS • Read all instructions before installing or using this appliance • Retain this manual for future reference • Use this appliance only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury. •... -
Page 6: Product Overview
3. PRODUCT OVERVIEW BB0120GD-NR BB0200GD-NR BB0330GD-NR BB0200GDS-NR BB0330GDS-NR Part Number 3736070-1 3736071-1 3736073-1 3736072-1 3736074-1 Height, mm External Dimension Depth, mm Width, mm 1350 1350 Capacity Litres Weight Net Volume Litres Air Circulation Type Fan Forced Fan Forced Fan Forced... -
Page 7: Installation
4. INSTALLATION Locating the Cabinet Ensure the following instructions are observed as this is vital for proper and trouble-free operation. • Do not install the cabinet outdoors. • Locate the appliance in a dry and well ventilated place. • The unit must be positioned on a level surface. •... - Page 8 Power Supply • The appliance must not be plugged into a multiple outlet power board. • The appliance is supplied with a flexible power cord fitted with a 3-pin plug. • The socket used must be properly earthed and fuse/RCD protected. •...
-
Page 9: Operation
5. OPERATION Start-up • Connect the appliance to the mains power supply and turn the Power switch On. • Allow the unit to operate for 1 hour to cool the compartment before placing items in the cabinet. • The compressor and condenser fan should operate should operate within 3 minutes after the Refrigeration switch is turned on. -
Page 10: Product Loading And Storage
6. PRODUCT LOADING AND STORAGE IMPORTANT: Run the refrigerator for at least 2 hours before loading. WARNING: : Do not store explosive substances such as aerosol cans with a flammable propellant inside the appliance. Start-up • Clean the interior surface with a soft cloth and warm water before loading. •... -
Page 11: Troubleshooting
Condenser Coil/Filter IMPORTANT: The filter and the condenser coil must be cleaned once a month. The filter can be removed for cleaning with water, make sure it is dried before reattaching. The condenser coil must be cleaned with vacuum/brush monthly to maintain the performance and minimise power consumption. -
Page 12: Environmental & Disposal Notes
9. ENVIRONMENTAL AND DISPOSAL NOTES These refrigerated cabinets are designed to high standards of environmental protection and recycling convenience. Cyclopentane, an environmentally friendly foaming agent, has been used. Cyclopentane is distinguished by zero ozone depletion potential (ODP) and zero global warming potential (GWP). The refrigerant used and contained within a hermetically tight circuit is environmentally friendly and does not contain chlorine and zero ODP. -
Page 13: Warranty
10. WARRANTY All Bromic products are manufactured to the highest quality standard and are supported by our Extra Care Service Warranty, including guarantees against any material or workmanship defects; guarantees that cannot be excluded under Australian Consumer Law. Warranty Terms vary across the range. Please ensure you are familiar with the Terms and Conditions that apply to the purchase of your Bromic product by referring to the Warranty Policy included with your purchased product. - Page 14 HOW TO PLACE A SERVICE REQUEST • Please call 1300 276 642 to place a warranty service request and let the operator know whether you need Priority A or B service. More information can be found below. • Ensure you have the serial number of your product ready before contacting us. •...
- Page 16 BROMIC REFRIGERATION 10 Phiney Place, Ingleburn (Sydney) NSW 2565 Australia T. 1300 276 642 For further product information bromicrefrigeration.com.au...