Hitachi 53SDX89B Operating Manual page 27

HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV
J
(_ PICTURE-IN-PICTURE buttons
See separate section on page 29 for a description.
(_PIP CH button
Use the PIP CH button to select between main picture and sub-picture tuning. The channel number which is green indicates which
channel is being controlled.
(_ HELP button
Press this button when a menu is displayed to view HELP text, which gives a description of the displayed menu. The HELP text will
be displayed every time a MENU is displayed, until this button is pressed again.
CONTRAST _ 4{mb.100%
BRIGHTNESS , m-'-"-'l _. 50%
COLOR "i Imlmlll'_l!_ 50%
TINT _ r_'_'l_.
SHARPNESS <lm'_l, 50%
RESET []
ADVANCED
SETTINGS
MENUITO MENU BAR TO QUIT J EXIT
A |,;_;,| PRESS• FORADEEPER "1
<1 I,..'_., PICTURE. PRESS ,TO
DECREASECONTRAST
CONTRAST II_
BRIGHTNESS ,m'_l_. 50%
COLOR 4mmimw_-_ _. 50%
TiNT <[r--'-lll_m--'-_ _.
SHARPNESS _m'_t_. 50%
RESET []
ADVANCED
SETTINGS
MENUITO MENU BAR TO QUIT I EXIT
(_) LAST CHANNEL (LST-CH) button
Use this button to select between the last two channels viewed. (Good for watching two sporting events, etc.)
LST-CH
ANTA 39
(_ VOLUME, MUTE buttons
Press the VOLUME up (/_) or down (V) button until you obtain the desired sound level.
To reduce the sound to one half of normal volume (SOFT MUTE) to answer the telephone, etc., press the MUTE button. Press the
MUTE button again to turn the sound off completely (MUTE). To restore the sound, press the MUTE button one more time, or press
the VOLUME Up (/_) button.
MUTE MUTE
(_ CHANNEL SELECTOR buttons
CHANNEL SELECTOR buttons are used to set Family Favorites, Channel Memory, etc.
Enter two or three numbers to select channels. Enter "O" first for channels 1 to 9. For channels 100 and above, press the =1"
button, wait until another dash appears next to the channel display on your TV, then enter the remaining two numbers using the
number buttons.
Channel selection may also be performed by pressing CH up (A) or down (Y).
I NOTE: The TV may not receive some channels if you are not in the correct SIGNAL SOURCE mode. (See page 39.) I
27