Advertisement
SERVICE AND ADJUSTMENTS
_
ARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST-
MENTS:
•
Depress clutch/brake pedal fully and set parking brake.
•
Place motion control lever in neutral (N) position.
•
Place attachment clutch in "DISENGAGED"
position.
•
Turn ignition key to "STOP" and remove key.
•
Make sure the blades and all moving parts have completely stopped.
•
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
TRACTOR
TO REMOVE
MOWER (See Fig. 17)
•
Place attachment clutch in "DISENGAGED" position,
•
Lower attachment lift lever to its lowest position,
•
Disengage belt tension rod (K) from lock bracket (L).
I&
CAUTION: Belt tension
rod is spring
I
i
loaded. Have a tight grip on rodand
I
release slowly.
•
Remove mower belt from electric clutch pulley (M),
•
Disconnect front link (E) from mower - remove retainer
spring and washer,
•
Go to either side of mower and disconnect mower
suspension arm (A) from chassis and rear lift link (C)
from rear mower bracket (D) - remove retainer springs
and washers.
•
Go to other side of mower and disconnect the suspen-
sion arm and rear lift link,
CAUTION: After rear lift links are dis-
connected, the attachment lift lever will
be spring loaded. Have a tight grip on
lift lever when changing position of
the lever.
•
Turn tractor steering
wheel to the left as far as it will
go,
•
Slide mower out from under right side of tractor,
TO INSTALL MOWER
(See Figs. 18-22)
Be sure tractor is on level surface and engage parking
brake,
•
Lower attachment lift lever to it's lowest position.
&
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
•
Turn steering wheel to the left as far as it will go and
position mower on right side of tractor with deflector
shield to the right,
FIG. 17
18
Advertisement
