Table of Contents
Advertisement
Operating temperature range: 32°F to 122°F (0°C to 50°C)
NOTE: This product is intended for use with a certified Class Limited Power Source, rated 5 Volts DC,
maximum 550 mA power supply unit.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio or television technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Important Note
Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF
exposure compliance. To maintain compliance with FCC RF exposure compliance requirements, please follow
operation instruction as documented in this manual. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter, except the transmitters built-in with the device.
US Information Concerning the Federal Communications Commission ("FCC") Requirements for Hearing
Aid Compatibility with Wireless Devices
When wireless devices are used near hearing devices (such as hearing aids and cochlear implants), users may
detect a buzzing, humming, or whining noise. Some hearing devices are more immune than others to this
interference, and wireless devices also vary in the amount of interference that they generate.
The wireless telephone industry has developed ratings to assist hearing device users in finding wireless
devices that may be compatible with their hearing devices. Not all wireless devices have been rated. Wireless
devices that are rated will have the rating displayed on the box together with other relevant approval markings.
The ratings are not guarantees. Results will vary depending on the user's hearing device and hearing loss.
If your hearing device is vulnerable to interference, you may not be able to use a rated wireless device
successfully. Consulting with your hearing health professional and testing the wireless device with your
hearing device is the best way to evaluate it for your personal needs.
This smartphone has been tested and rated for use with hearing aids for some of the wireless technologies
that the smartphone uses. However, other wireless technologies may be used in this smartphone that have
not been tested for use with hearing aids. It is important to try the different features of your smartphone
thoroughly and in different locations to determine if you hear any interfering noise when using this smartphone
with your hearing aid or cochlear implant. Consult your wireless service provider about its return and
exchange policies, and for information about hearing aid compatibility.
Hearing aid compatibility rating for this smartphone: M4/T4
How the ratings work
M-Ratings: Wireless devices rated M3 or M4 meet FCC requirements and are likely to generate less
interference to hearing devices than wireless devices that are not labeled. M4 is the better or higher of the
two ratings.
T-Ratings: Wireless devices rated T3 or T4 meet FCC requirements and are likely to be more usable with a
hearing device's telecoil ("T Switch" or "Telephone Switch") than unrated wireless devices. T4 is the better or
higher of the two ratings. (Note that not all hearing devices have telecoils in them.)
Hearing devices may also be measured for immunity to this type of interference. Your hearing device
manufacturer or hearing health professional may help you find results for your hearing device. The more
immune your hearing aid is, the less likely you are to experience interference noise from wireless devices.
For more information about the actions that the FCC has taken with regard to hearing aid compatibility with
wireless devices and other steps that the FCC has taken to ensure that individuals with disabilities have access
to telecommunications services, visit www.fcc.gov/cgb/dro.
SAR Information
1.08 W/kg @ 1g (HEAD)
1.21 W/kg @ 1g (BODY)
THIS MODEL DEVICE MEETS THE GOVERNMENT'S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES. For
body worn operation, this phone has been tested and meets the FCC RF exposure guidelines when used with
the TCL Communication Ltd. Accessories supplied or designated for this product. Use of other accessories
may not ensure compliance with the FCC RF exposure guidelines. Your wireless mobile phone is a radio
transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure
to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government.
These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general
population. The guidelines are based on the safety standards previously set by both U.S. and international
standards bodies:
•
American National Standards Institute (ANSI) IEEE. C95.1-1992 .
•
National Council on Radiation Protection and Measurement (NCRP). Report 86. 1986.
•
International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1996.
•
Ministry of Health (Canada), Safety Code 6. The standards include a substantial safety margin designed
to assure the safety of all persons, regardless of age and health.
The exposure standard for wireless mobile phone employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg*.
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated
as in compliance with the FCC RF exposure guidelines. SAR information on this model device is on file
with the FCC and can be found under the Display Grant section of https://fjallfoss. fcc.gov/oetcf/eas/reports/
GenericSearch.cfm after searching on FCC ID: 2ACCJN023. Additional information on Specific Absorption
Rates (SAR) can be found on the Cellular Telecommunications & Internet Association (CTIA) Web-site as
http://http://www.ctia.org/.
Advertisement
Table of Contents
