Table of Contents
Advertisement
THROTTLE
CONTROL
5. Attach the throttle control to the back side of han-
dle, Fig. 4.
4
LOCK
WASHER
is-24 HEX. NUT
Slide the threaded part of control into slot on the
back of handle. Slide the 58 lock washer and 36-24
hex. nut up the control cable and secure control to
handle by tightening the hex. nut to the control from
underside of the slot.
CONTROL
CABLE
6. Reposition
the outer tine hub assemblies
to the
proper end of tine shaft, Fig. 5. Note: For ship-
ping purposes, this tiller was shipped with the outer
tine hub assemblies on the opposite end of the shaft.
Slide each outer tine hub assembly from tine shaft
N me
Ea
Е
.
TINE ЗНАЕТ".
L
and install ошо the opposite end of tine shaft. Be
—
sure the tilling edges (tapered edges) are facing the
same forward direction as the inner tine hub assem-
J
W LOCK WASHER
When the hole in the hub assembly lines up with
OUTER TINE HUB
' in-24 НЕХ, NUT
the hole in the tine shaft, insert a is-34 x 134 hex.
ASSEMBLY
"FINE THREAD"
hd. heat treated cap screw* and secure with a +6
lock washer' and 36-24 hex. nut' ("fine thread").
FIG. 5
Assemble the other outer tine hub assembly follow-
ing the same instructions as outlined above.
af
ja
7. "ш
the control
lever
assembly
to the handle,
А 08 56 Р, AEC
"LONG"
CLEVIS PIN
er
RUBBER SPACER.
aid,
Secure
the (2) rubber spacers*, (2) Зв S.A.E.
flat
W
BABE.
l
Co.
:
\
Washers* and the control lever" to the bracket on
FLAT WASHER
yl
| \
к
1
the backside of handle, as shown in Fig. 6, using
CONTROL LEVER
~ RUBBER SPACER
*This item can be found in the hardware bag.
FIG. 6
Advertisement
Table of Contents
