Advertisement
Alignment and Adjustments
2-1-6 ACTUATOR GAIN Adjustment
1) Before Adjustment
1. On the Factory Transmitter's display -> Move to Factory Mode, then select ACTUATOR GAIN for the
SP Actuator.
2) Making Adjustments
1. As shown in the picture above, change the actuator values to eliminate saw tooth shapes from the
A and B areas.
- To fine tune, increase the data value ensuring that you get the center between the starting and
ending points of the disappearing saw tooth shape.
-> Move "5" steps further from the point where A disappears.
2. To fine tune the upper and lower areas, refer to the saw tooth shape (in the picture below) and the red,
green, blue and white crosshair shape (as shown above) respectively for further adjustment.
2-18
Samsung Electronics
Advertisement
