2. The lamp type is indicated on the right side of the TV. It is also indicated on the lamp case. 3. After checking the code number for the lamp, give the code number to the store where you purchased the TV or to a Samsung Service center. • Caution 1.
Page 2
• For replacement, you will need a 5.91 Inches-long Phillips screwdriver and a pair of gloves. Unplug TV, then use a screwdriver to remove the screw. Remove the Lamp cover. Remove the screws securing the Lamp by using a screwdriver. Separate the Lamp from the engine by holding the handle and pulling it out.
Your New Wide TV List of Features Your TV was designed and engineered using the latest technology. It is a full-featured, high-performance unit that exceeds industry standards. In addition, it has these special features: • Easy-to-operate remote control • Easy-to-use on-screen menu system you can access from the side panel or remote control •...
Side Panel Buttons The buttons on the right side panel control your TV’s basic features, including the on-screen menu system. To use the more advanced features, you must use the remote control. Press to switch between viewing TV programs and signals from connected components. Press to see the on-screen menu.
Your New Wide TV Front Panel LED Indicators The three lights on the front panel indicate the status of your TV. POWER Press to turn the TV on and off. Remote Control Sensor Aim the remote control towards this spot on the TV. : Light is On : Light is Blinking : Light is Off...
Rear Panel Jacks Use the rear panel jacks to connect components such as a VCR. You can connect different components such as VCRs, Set-Top Box and a DVD player etc., because there are two sets of video input jacks and three set of component video input jacks on the rear panel of your TV.
25. PIP Controls Selects a target device to be controlled by the SIZE; Press to select the size of PIP window. Samsung remote control (i.e., TV, STB, VCR, SWAP; Press to exchange the video signal that CABLE, or DVD). is currently displayed on the main screen with 12.
Page 8
Installing Batteries in the Remote Control With normal use, the batteries in the remote control should last about a year. If you notice a performance degradation while using the remote, the batteries may need to be replaced. Make sure you replace both batteries and do not mix old and new batteries in the remote control.