Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Esse-ti GSM200 C
Summary of Contents for Esse-ti GSM200 C
- Page 1 Installation and User’s manual 7IS-80146...
- Page 2 The User shall be responsible for defects arising from the use of the product. Esse-ti shall only be responsible for defects according to and within the limitations set by the Presidential Decree dated 24/05/1988 no.
-
Page 3: Table Of Contents
ST56 / Helpy Star ................... 11 STARTING ..................12 Test call ....................13 Module mounting operations ..............13 GSM200 C installation recommendations ..........14 EU Declaration of Conformity .............. 14 SIGNALLING .................. 15 LED indicating device operation status (RED) ........15... -
Page 4: General Instructions For The Installer
The product must be EXCLUSIVELY used for the purpose it was designed for. Esse-ti shall not be responsible for damages arising from improper use. The product has been designed in compliance with the regulations in force and must be installed in systems that comply with the provisions of law. -
Page 5: Description
DESCRIPTION The GSM200 C module can be used in conjunction with the following Esse-ti elevator alarm systems: Helpy 2W-TL Helpy 2W-LCP Helpy L300 Helpy L300 TL Helpy L200 Helpy L200 TL ST60 ST61 Helpy Quick Helpy Quick-TL Helpy Vox ST56 Helpy Star. -
Page 6: Installation
INSTALLATION Remove the cover. ANTENNA connector SIM CARD housing LED indicating signal strength (green) LED indicating device operation status (red) RJ45 for module connection to Esse-ti elevator alarm systems Page 6... -
Page 7: Inserting The Sim Card
Inserting the SIM card Before inserting or replacing the SIM card, always make sure that the module has been disconnected from the mains and take all necessary measures to avoid electrostatic discharge. Shift the SIM card housing cover downward and lift it. ... -
Page 8: Inserting The Antenna
Screw the antenna cable in to the connector on the top of the module. WARNING NEVER connect GSM200 C module without having installed the antenna. The module may damage. WARNING Do not install the product near other electric or electronic devices that were not especially designed to be used with it. -
Page 9: Programming
PROGRAMMING When using the GSM200 C module for connection with any Esse-ti alarm system, please make sure the parameter “Programming the type of telephone line” has been adequately set in the specific alarm system. Lift the local telephone handset of the elevator alarm system. -
Page 10: Connections
Insert the provided cable (pin-to-pin cable) in to the two RJ45 connectors located on the Helpy 2W-TL / Helpy 2W-LCP and GSM200 C module. In order to reach longer distances (up to 100 m), please use a cat.5 or higher cable. -
Page 11: St60 / St61 / Helpy Quick / Helpy Quick-Tl / Helpy Vox
PSTN line board. Insert the provided cable (pin-to-pin cable) in to the two RJ45 connectors located on the ST56 / Helpy Star and GSM200 C module. In order to reach longer distances (up to 100 m), please use a cat.5 or higher cable. -
Page 12: Starting
STARTING After the connection, wait 1 minute to give time to the GSM200 C to register correctly with the GSM network. Make sure the red LED (device status) flashes briefly once every 3 seconds as shown in the paragraph “Signalling”. -
Page 13: Test Call
Drill two holes with 5 mm diameter on the wall at a distance of 50 Insert the 2 fischers and screw down until the screws are at a 5 mm distance from the wall. Place the GSM200 C module onto the two screws. Page 13... -
Page 14: Gsm200 C Installation Recommendations
The module is provided with a 3 m cable. Use a cat. 5 or higher cable to connect the GSM200 C module at a longer distance (up to 100 m). The minimum recommended distance, between the GSM200 C module and the elevator alarm system, is 50 cm. -
Page 15: Signalling
Upon switch on, it indicates GSM network login in progress; if it keeps blinking, it may indicate that the GSM200 C has not been correctly registered with the network, the SIM card is protected by the PIN code or other problems. - Page 16 GSM200 C Rel. dated 19/12/2018 Esse-ti S.r.l. Via G. Capodaglio, 9 62019 Recanati (MC) – ITALY Tel. +39 071 7506066 Fax +39 071 7506057 www.esse-ti.it support@esse-ti.it...
Need help?
Do you have a question about the GSM200 C and is the answer not in the manual?
Questions and answers