Advertisement
ANTENNA CONNECTIONS
FM ANTENNA
FM T-type antenna attachment
Connect the accessory FM T-type antenna to the FM terminals.
Stretch the antenna cut to its full length, and affix it to a wall,
etc.
Stretch out both ends.
|
I
i
I
i
Correct
Wrong
Wrong
The accessory
FM T-type antenna
must
be connect to ensure
proper reception.
+
+28)
OO
CONNECTIONS
External FM antenna installation
Use an external antenna when the signals from the station are
weak
and cannot
be picked
up by the accessory
FM T-type
antenna, or when the sound is accompanied by large amounts of
noise.
There
are
two
ways
of connecting
the external
FM
antenna to the ANTENNA terminals with 300Q feeder wire, or
with a 75@ coaxial cable.
itis recommended that you use the 75Q coaxial cable, so that the
effects of extraneous noise are reduced to a minimum.
When the connecting cable
is a 75Q coaxial cable
75Q coaxial cable
When the connecting cable
is a 300Q feeder wire
3008 feeder
* Plug the power cord into the household electrical outlets only
after all the connections have been completed
Proceed as follows with the set-up and connections
1. Connect the FM antenna and the AM
antenna to the
cassette tape deck receiver's ANTENNA
terminals.
(See
page 3~~4)
{Use an antenna ground as necessary.)
2. Connect the turntable's cords to the cassette tape deck
receiver's
TURNTABLE
jacks.
if
any
other
stereo
component
is used,
connect
in the same
way
to the
cassette tape deck receiver's input (and output) jacks.
3. Connect the speaker cords to the SPEAKERS terminals.
A, Finally, connect the power cord to the AC wall socket.
CONNECTING THE POWER CORD
(For U.S. and Canadian models)
Household
electrical
outlets
are
provided
with
specific
polarity, a live side and a neutral (ground) side. This unit
utilizes such polarity in order to improve sound quality. As
shown in the illustration, be sure to insert the power plug so
that its blades match the width of slots in the outlet.
Household electrical cutlets
Ol)
Long slot is neutral
ni
(ground) side.
—¥ cg
insert the wide blade
into the ground side slot.
4
<ARB1246>
Connecting the input/output cords
R
L
¢ The white terminal is for the left channel
and the red
terminal is for the right channel.
Connecting the speaker cords.
1. Cutter
2. Twist the strands.
Speaker
2d
cord
|_|
10 mm
4. Pull the lever
toward the inside
Ag
3. Push the fever
toward the outside
Advertisement
