RADEMACHER 9600 00 86 Manual page 2

Only RolloTube S-line
1.
First switch on the continu-
ous phase.
Continue with point 2.
RolloTube C/M and S-line
2.
Move the roller shutter in
the desired direction
with button 1.
Recommendation
First in the up direction.
3.
In addition ...
4.
Release the button again
as soon as the desired end
point is reached.
5.
You can adjust the end
point in small steps by
briefly pressing the button.
6.
Switch off the specified
direction of travel after
successfully setting the
end points.
The respective end point
is stored.
Only RolloTube S-line
7.
Switch off the continuous
phase.
Exiting end point setting, see next column.
Only RolloTube S-line
1.
First switch on the continu-
ous phase.
Continue with point 2.
RolloTube C/M and S-line
2.
Connect both directions of
travel to the mains supply
for approx. 5 seconds until
the tubular motor confirms
this by briefly running up
and down.
After that the factory set-
tings are loaded.
ON/
SET
The LED on
button 3 must
light up continu-
ously.
Direction of
I
travel 1
or
Direction of
II
travel 2
Press/tap twice
III
briefly and press
and hold the third
time.
III
III
I
Set the rocker
switch to the
centre position.
II
ON/
SET
ON/
SET
The LED on
button 3 must
light up continu-
ously.
or
Switch button 1
I II
to any position
and
press
III
button 2.
Exiting end point setting / factory settings
1.
Remove the mains plug from the socket.
2.
Disconnect the motor connecting cable.
3.
Reconnect the tubular motor to the mains.
◆ After the end point setting
Connect the tubular motor to the mains as specified in the
respective operating manual.
◆ After loading the factory settings
Restore the original tubular motor connection.
RADEMACHER Geräte-Elektronik GmbH hereby de-
clares that the universal setting cable complies with the
Directives 2014/30/EU (EMC Directive) and 2014/35/
EU (Low Voltage Directive) as well as 2011/65/EU
RoHS 2 Directive.
The full text of the EU declaration of conformity is availa-
ble at the following website.
www.rademacher.de/ce
Warranty terms and conditions
Information about the warranty conditions of our products can be
found on our homepage.
RADEMACHER
Geräte-Elektronik GmbH
Buschkamp 7
46414 Rhede (Germany)