Advertisement
OPERATING YOUR VACUUM CLEANER
How to use the blower
For locations where the nozzle will
not enter, connect the hose to the
blower and blow the dust out.
NOTE
• When traveling over steps in the floor, always hold the
vacuum cleaner by the handle so that it does not fall over.
• When using the crevice tool, the vac gauge does not
display correctly, so remove the crevice tool before
checking the vac gauge.
Carrying handle
6
1
Turn on the ON/OFF switch.
2
Use the nozzle that is appropriate for the location you are cleaning.
Flooring: Press lever A Carpet: Press lever B
A
B
• Lift the nozzle off the floor, and if the vac gauge turns red, discard the dust.
• To decrease the suction power.
• If the vac gauge turns red when crevice tool is used, adjust the suction regulator.
To clean the dust in difficult to reach places
• Turn the hose connection wand until the projection is hidden by the groove,
as shown in the diagram.
Groove
Projection
7
Advertisement
