Advertisement
4. Clear all data memory. CAUTION. This will clear all the receiver memory. This is
necessary only when an Initial Set Up is required.
a. Press FUNCTION.
b. Select No. 3, Installation.
c. Select No. 4, All Data Clear.
d. Select No. 1, Yes.
e. Press ENTER. The screen will now display, "Satellite Memory is all cleared. Move dish
to East Limit (EL). Then ENTER."
5. Set the Antenna limits.
a. Press and hold the EAST key until the screen displays, "Error. No Return Pulse." To
avoid possible damage to the actuator or other out door components, have an assistant
near the dish to warn you when the dish is reaching its limit.
b. Release the EAST key when the "No Return Pulse" message is displayed.
c. Press and hold the WEST key for about 1 to 2 seconds.
d. Press ENTER. The screen now displays, "Move dish to West Limit (WL). Then
ENTER."
e. Press and hold the WEST key until the screen displays, "Error. No Return Pulse." Have
your assistant watch the dish to avoid any damage as the dish moves towards its western
limit.
f. Release the WEST key when the "No Return Pulse" message is displayed.
g. Press and hold the EAST key for about 1 to 2 seconds.
h. Press ENTER. The antenna limits are now set.
6. Program the satellite positions. Refer to a current Satellite Television Guide. Locate the
satellite channel chart pages. This chart shows you where the satellites are and what
channels are active. Since the dish is at its West Limit, start with the furthest west satellite.
At the time this booklet was written, that was Satcom C1 (F1).
a. Turn on the Channel Scan and Auto Tune.
1) Press FUNCTION.
2) Select No. 1, Set-Up.
3) Select No. 2, Channel Scan.
4) Use the EAST or WEST key to turn the Channel Scan ON.
5) Select No. 3, Auto Tune.
6) Use the EAST or WEST key to turn the Auto Tune ON.
7) Press VIEW.
b. Press and hold the EAST key for 2 to 3 seconds. Allow the receiver to scan through the
channels. The channel scanning will stop on a strong video signal. Press and hold the
EAST key for another 2 to 3 seconds. Allow the receiver time to scan through all the
channels again. Repeat short east moves until the receiver locks on a channel. The
picture may be snowy or scrambled.
c. Use the Channel UP or DOWN keys to view other channels. The receiver may start
scanning again. Wait until it stops scanning. Identify any active channel on this first
satellite. You may need to use the EAST or WEST keys a little to get a clear enough
picture.
d. When you are sure this is the desired satellite, press the C-SAT key (Ku-SAT, if a Ku
satellite), followed by the alphanumeric name. (In this example, Satcom C1 can be called
C 1 or F 1.)
TRX 15, TRX 1500, TRX 1520
5
Advertisement
