Traxxas SLASH BRUSHLESS 58134-4 Owner's Manual page 23

RECEIVER BOX:
MAINTAINING A WATERTIGHT SEAL
Removing and Installing Radio Gear
The unique design of the receiver box allows the removal and
installation of the receiver without losing the ability to maintain a
watertight seal in the box. The patent-pending wire clamp feature
gives you the ability to also install aftermarket radio systems and
maintain the watertight features of the receiver box.
Removing the Receiver
1. To remove the cover, remove the two 3x8mm button-head cap
screws.
2. To remove the receiver from the box, simply lift it out and set to the
side.
The antenna wire is still inside the clamp area and cannot be
removed yet.
3. Remove the wire clamp by removing the two 2.5x8mm cap screws.
4. Unplug the servo cables from the receiver and remove the receiver.
Receiver Installation
1. Always install the wires into the receiver
box before installing the receiver.
2. Install the antenna wire and the servo
cables into the receiver box.
3. Arrange the wires neatly using the wire
guides in the receiver box (A). The excess
wire will be bundled inside the receiver box. Label
which wire is for which channel.
4. Apply a small bead of silicone grease (Traxxas
part #1647) to the wire clamp (B).
5. Install the wire clamp and tighten the two
2.5x8mm cap screws securely.
6. Install the receiver into the box and plug the
wires into the receiver (C). Refer to page 12
for the wiring diagram.
7. Make sure the box light pipe is aligned with the receiver LED. Make
sure the O-ring is properly seated into the groove in the receiver box
so that the cover will not pinch it or damage it in any way.
8. Install the cover and tighten the two 3x8mm
button-head cap screws securely.
9. Inspect the cover to make sure that the O-ring seal is not visible.
A
B
C
DRIVING YOUR MODEL
SLASH BRUSHLESS • 23