Traxxas SLASH BRUSHLESS 58134-4 Owner's Manual page 14

Battery iD
Traxxas recommended
battery packs are equipped
with Traxxas Battery iD. This
exclusive feature allows
Traxxas battery chargers (sold
separately) to automatically
recognize connected battery
packs and optimize the
charge settings for the
battery. This eliminates
the need to worry over
charger settings and menus
for the easiest and safest
charging solution possible.
Visit Traxxas.com to learn
more about this feature and
available Traxxas iD chargers
and batteries.
4 4
14 • SLASH BRUSHLESS
TRAXXAS TQ 2.4GHz RADIO SYSTEM
INSTALLING THE BODY
Your Slash Brushless includes an innovative latching system for
securing the body to the chassis (body clips are not required).
To remove the body for chassis access:
1. Reach beneath the truck body and pull the latches toward the
outside of the truck body to release them from the front and rear
body mounts.
2. Push up on the latches to fully disengage them from the mounts.
3. Lift the body straight up from the chassis. Lift the front and rear of
the body evenly or it may become difficult to remove.
To reinstall the body:
1. Position the body on the chassis. Align the front and rear of the
body with the bumpers.
2. Press down on the body at each latch location until the latches
snap into place.
Note: To keep the clipless system functioning properly, periodically
inspect and clean the latches in the body and the slots on the
front and rear body mounts. If dirt and grime accumulate on these
components, the clipless system will not operate smoothly.
INSTALLING THE BATTERY PACK
Install the battery pack with
the battery wires facing the
rear of the model. Insert the
tabs of the battery hold-
down into the slots in the
rear hold-down retainer and
then place the battery hold-
down over the post. Secure
the battery hold-down with
body clip in the hole in the
post. Do not connect the
battery pack yet.